Expert Answers about Itasca Meridian Motorhome

• Vent Cover Recommendation for Fan-Tastic Roof Vent 2000DM
• Yes, I was able to pull up pictures of the Fan-Tastic roof vent 2000DM and it uses the same vent lid as the part # FVK1020-19 that you referenced.
  view full answer...


• Recommended Storage Cover for 2013 Itasca Meridian Motorhome
• I suggest you go with the Adco Olefin HD All-Climate RV Cover for Class A Motorhome, # AD84ZR. This is the up to 40' fit, use the cinch strap at front and rear to pull that extra 18 inches in for a tight fitment.
  view full answer...


• Troubleshooting Motor On Kwikee Steps Continuing To Run After Steps Are Fully Opened Or Closed
• I reached out to my contact at Lippert and the issue you are describing on the Kwikee Steps on your 2013 Itasca Meridian 34B is a tell tale sign of a bad controller. The cause is the controller is not detecting the amp draw of the motor when the steps are fully opened/closed and is causing the motor to keep running after the step is fully opened/closed. The Controller # LC363980 you were looking at is a replacement for Kwikee Revolution Steps. If that is not what you have on your Motorhome...
  view full answer...


• Is a Battery Charge Line Needed When Flat-Towing a 2020 Jeep Grand Cherokee
• The Roadmaster Battery Charge Line Kit for Towed Vehicles part # RM-156-25 can be installed on a 2020 Jeep Grand Cherokee. If you will be pulling power from the vehicle's battery while in tow then it would be a good idea to use the charge line to ensure you don't have a dead battery when you arrive at your destination and are ready to unhook the vehicle from the motorhome.
  view full answer...


• Air Conditioner Replacement Recommendation for 2011 Itasca Meridian 34Y
• I don't have a way to know what specific AC units you have on your 2011 Itasca but we most likely have a solid unit that would work well as a replacement. If you have a Dometic unit know you could use the Advent Air RV AC unit part # ACDOM135B which was designed to replace a Dometic. This means it will plug right into your current wiring and allow you to use your current controls and wiring connectors. If you have a Carrier unit instead we have the part # ACCAR135B, or a Coleman you'd want...
  view full answer...


• Recommended Brake Controller For My 2006 Itasca Meridian Motorhome
• If you want to tow a trailer or use a tow dolly with your 2006 Itasca Meridian Motorhome, you will need a brake controller. My brake controller recommendation is the Redarc you inquired about. It will consist of the following items: Redarc Tow-Pro Elite Trailer Brake Controller - 2 Braking Modes - 1 to 3 Axles - Proportional, part # RED44FR Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers, part # 3027-P This brake controller comes with a custom wiring harness. It is a proportional...
  view full answer...


• Sway Bar Recommendation for 2013 Itasca Meridian 34b Motorhome
• For your 2013 Itasca Meridian 34b Class A Motorhome which is built on a 2013 Freightliner XC chassis Roadmaster makes a front sway bar part # RM-1209-136 which is a fit and will work great but they do not make a rear sway bar.
  view full answer...


• SnapPad Jack Pads for Itasca Meridian Motorhome
• To obtain SnapPad Jack Pads that are a fit for your 2014 Itasca Meridian motorhome you will need to measure the size of your existing jack pads. They will probably be 10" is diameter. Measure all pads as sometimes the front pads and rear pads will be a different size. Next, determine the shape of the pads. They could be round, square or octagon. Finally, let us know if the existing pads are flat or if they have a lip around the edges. With this information we can offer you a confirmed...
  view full answer...